[Apr 26, 2024] Dumps Collection JN0-363 Test Engine Dumps Training With 293 Questions
Juniper JN0-363 Dumps - 100% Cover Real Exam Questions
NEW QUESTION # 168
Click the Exhibit button. In the exhibit, all routers are sending routes to Router B
Which routes will be advertised from Router B to Router D?
- A. BGP routes learned from Routers A and C only
- B. BGP routes learned from Routers A, C and E only
- C. BGP routes learned from Router E only
- D. BGP routes learned from Router A only
Answer: B
NEW QUESTION # 169
Click the Exhibit button. An interface is configured as shown in the exhibit. What must also be configured for this interface to participate in VLAN 100 and 200?
- A. VLANs
- B. bridge domains
- C. encapsulation type
- D. broadcast domains
Answer: B
NEW QUESTION # 170
Referring to the exhibit, what is the minimum number of LSPs required to support alt four networks?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: A
NEW QUESTION # 171
What is the size of the unique address used to identify each node on an Ethernet LAN?
- A. 12 bytes
- B. 3 bytes
- C. 6 bytes
- D. 9 bytes
Answer: C
NEW QUESTION # 172
You are advertising a summary route that represents your local network (172.20.0.0716) to both ISP A and ISPB. You want to influence all traffic sent to you from ISP C to go through R2.
How would you accomplish this task?
- A. On R2. prepend your AS number three times on the 172.20.0.0/16 route when advertising it to ISP 2.
- B. On R2, change the local preference value to 50.
- C. On R1, change the local preference value to 250.
- D. On R1, prepend your AS number three times on the 172.20.0.0/16 route when advertising It to ISP 1.
Answer: C
NEW QUESTION # 173
Click the exhibit.
Referring to the exhibit, which configuration must be set on R2 to from a Level 1 IS-IS adjacency with R1?
- A. Set interfaces lo0 unit 0 family iso address 49.0002.3415.0010.0250.0000.0046.00
- B. Set interfaces lo0 unit 0 family iso address 49.0002.3414.0010.0250.0000.0046.00
- C. Set interfaces lo0 unit 0 family iso address 49.0001.3415.0010.0250.0000.0046.00
- D. Set interfaces lo0 unit 0 family iso address 49.0001.3414.0010.0250.0000.0046.00
Answer: C
NEW QUESTION # 174
Click the Exhibit button.
Both configuration hierarchies shown in the exhibit have been committed to your MX Series device.
Which two statements are true in this scenario? (Choose two.)
- A. Traffic destined to 10.3.0.1 will use the R1-to-R6 LSP as a next hop
- B. Traffic destined to 10.3.0.1 will not use the R1-to-R6 LSP as a next hop
- C. The active 10.3.0.0/24 prefix installed in the route table will have a route preference of 5
- D. The active 10.3.0.0/24 prefix installed in the route table will have a route preference of 7
Answer: A,D
NEW QUESTION # 175
Exhibit
The exhibit shows a topology with 1 Gbps interfaces between routers, and four RSVP LSPs operating with the respective bandwidth reservations.
Which path will be selected for a new LSP from R4 to R6 with a bandwidth reservation of 400 Mbps?
- A. R4 -> R1 -> R2 -> R5 -> R6
- B. R4 -> R5 -> R2 -> R3 -> R6
- C. R4 -> R1 -> R2 -> R3 -> R6
- D. R4 -> R5 -> R6
Answer: A
NEW QUESTION # 176
Which two statements describe operations performed by the encapsulating tunnel endpoint in an IP-IP tunnel? (Choose two.)
- A. It decrements the time-to-live (TTL) counter by one in the inner IP header
- B. It adds an outer IP header with the destination address of the remote tunnel endpoint
- C. It creates and adds a new inner IP header with the remote destination device's IP address
- D. It modifies the source and destination addresses in the inner IP header
Answer: A,B
NEW QUESTION # 177
Click the Exhibit button. An interface is configured as shown in the exhibit. What must also be configured for this interface to participate in VLAN 100 and 200?
- A. VLANs
- B. bridge domains
- C. encapsulation type
- D. broadcast domains
Answer: B
NEW QUESTION # 178
Click the Exhibit button. The policy shown in the exhibit has been configured and installed on your router.
What is the result of applying this policy?
- A. The 172.18.1.0/24 network will be redistributed into OSPF as an external route.
- B. The 172.18.1.0/24 network will be redistributed into OSPF as an internal route.
- C. The 172.18.1.0/32 network will be redistributed into OSPF as an external route.
- D. The 172.18.1.0/32 network will be redistributed into OSPF as an internal route.
Answer: A
NEW QUESTION # 179
Which BGP message type is used to re-advertise routes that have already been sent to a peer and acknowledged using TCP?
- A. notification
- B. refresh
- C. keepalive
- D. update
Answer: B
Explanation:
The BGP (Border Gateway Protocol) refresh message is used to request the re-advertisement of the IPv4 unicast or multicast routing information that was previously sent by the sender to the receiver and acknowledged using TCP. This message helps in refreshing the routes in case of route table changes or to ensure that the receiver has the latest and most accurate routing information.
NEW QUESTION # 180
Referring to the exhibit, what will happen to untagged frames?
- A. The untagged frames are associated with VLAN 10.
- B. The untagged frames are load balanced between VLAN 10 and VLAN 20.
- C. The untagged frames are dropped.
- D. The untagged frames are associated with VLAN 20.
Answer: D
NEW QUESTION # 181
Click the Exhibit.
You have just configured IS-IS, but the adjacency is not coming up.
Referring to the exhibit, what is the cause?
- A. One router is configured for Level 2 only.
- B. The routers must be in different areas.
- C. Only one side is configured using the point-to-point parameter.
- D. The family iso parameters is missing on the interfaces.
Answer: C
NEW QUESTION # 182
An OSPF router does not have a router ID configured. In this scenario, which statement is correct about the router ID?
- A. The Junos OS will use the IP address assigned to the loopback interface for the router ID.
- B. A router ID will not be assigned until it is manually configured.
- C. The Junos OS will use the IP address assigned to the interface with the lowest MAC address.
- D. The Junos OS will use the IP address assigned to the Interface with the highest priority.
Answer: B
NEW QUESTION # 183
Click the Exhibit button. From the output shown in the exhibit, what would happen to a packet destined for address 172.29.3.5?
- A. The address is not in the aggregate range; the packet will be forwarded.
- B. The address is in the aggregate range; the packet will be dropped.
- C. The address is not in the aggregate range; the packet is sent to the Routing Engine.
- D. The address is in the aggregate range; the packet will be silently dropped.
Answer: B
NEW QUESTION # 184
......
Realistic Exams4Collection JN0-363 Dumps PDF - 100% Passing Guarantee: https://easytest.exams4collection.com/JN0-363-latest-braindumps.html
